15
stop scanning when it receives the next broadcasting station of adequate signal
strength.
5. Press the volume control
Button
on main unit or
VOL+ /
–
Button
on
the
remote control to adjust the volume control to the desired volume level.
FM & FM-Stereo reception
-
When listening to the FM radio, press the
FM ST/MODE Button
on
the
remote
control to switch between stereo mode and mono mode.
The
FM stereo icon
“
((ST))
＂
will appear on the display if unit is in stereo mode. It is preferable to
receive the program in mono when you are receiving a weak station.
HINTS FOR BEST RECEPTION:
The receiver has a build-in FM wire antenna hanging from the back of the cabinet.
This wire should be totally unwrapped and fully extended for the best reception.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station,
so weak stations may be skipped. You can manually tune to find the weak
stations if a station gets skipped. With strong signals, the tuner may stop
before it reaches the actual broadcast frequency, so you may need to
manually tune for the best reception.
PRESET RADIO STATIONS
1. Press the
POWER
Button
on main unit or remote control to turn on the unit.
2. Tap the
FUNCTION Button
on main unit or remote control to select Radio mode.
3. Tune to the desired radio station either by “manually” or “automatically” tuning
method.
4. Press the
PROG/PRESET Button
on remote control; the next available preset
memory number flash in the LED display. (Note:”P01” will blink in the display if
you are programming preset for first time)
5. Tap the
▲
or
▼
Button
on remote control to select the preset number you want
to assign the station to.
6. Press the
PROG/PRESET Button
on remote control to confirm the setting.
7. Repeat step #3 thru # 6 to preset up to 20 stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the
▲
or
▼
on remote
control repeatedly.
NOTE:
The clock and radio station presets will need to be reset if the power is interrupted or
in the event of a power outage. “12:00” will appear and start blinking on the LCD
display to notify you that the power was interrupted and the clock will need to be reset.
Please follow steps 1-7 above to resave the preset stations.
/
Button
