E-11
ACTIVE/DE-ACTIVE ALARM FUNCTION
1. To active ALARM, tap the “
ALARM
”
Button
once, and the alarm icon “
” will show on LCD
display.
2. Cancel the ALARM function by tapping on the “
ALARM
”
Button again. T
he alarm icon “
” will
go off.
Wake to Radio, CD or Beeping Alarm
When the alarm time is reached, the CD, radio or beeping alarm will sound for
60 minutes
then shut off and reset itself for the following day (without pressing
the snooze button).
To stop the alarm immediately after it sounds, tap the
Power
B
utton
on remote control
or on main unit. The alarm will now reset for the following day.
To cancel the following day alarm, tap the
ALARM Button
once, the ALARM icon “
”
on
the display goes off.
The Beeping Alarm is a crescendo alarm, so the beeping will start at a low volume level and
gradually increase to a louder level.
SNOOZE FUNCTION
Press the
SNOOZE Button
on remote control once to
activate the SNOOZE function and
temporarily stop the alarm from sounding for 9 minutes. The SNOOZE icon shows on display and
the alarm will re-start again after 9 minutes on each press. To cancel the SNOOZE mode, press the
POWER/STANDBY
Button
once, the SNOOZE icon disappears from display.
NOTE:
The SNOOZE feature is only active for 60 minutes after the original alarm time. You can
press the SNOOZE Button again multiple times as long as it’s within that 60 minute active period,
and as long as a minimum of 9 minutes remain.
Once the 60 minutes expires, the alarm will stop
until next day
.
RADIO OPERATION
1. Tap
the
POWER/STANDBY
Button
on the main unit or remote control to turn on the unit.
2. Tap
the
MODE Button
on main unit or remote control to select FM/AM mode, the FM/AM radio
frequency appear in display.
3. To manually tune to a specific radio station, tap the
TUNE
Button
on either main
unit or remote control repeatedly. Use the manual tuning method to tune in weaker stations that
are bypassed during Automatic Tuning.
4. To
automatically tune to the next available radio station, press and hold the
Button
on main unit or remote control for 1-2 seconds until frequency readout on the display
begins to scan and then release the button. The tuner will stop scanning when it receives the
next broadcasting station of adequate signal strength.
5. Rotate
the
VOLUME
knob on main unit or press the
VOL+/-
buttons on remote control to adjust
the volume control to the desired volume level.
FM / FM Stereo reception
When listening to the FM radio, press the
ST./MONO Button
on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
or
or
