JEI SOLUTIONS LTD
MAGBEAST HM40
5.2 (20130122)
Operators manual for Drilling Machine Magbeast HM40
- 5 -
Safety chain can also secure the drill through
the handle
.
6)
Do not use the machine in explosive environmental areas.
7)
Do not start work if the machine has excessive play on guide slides.
8)
Always wear safety goggles and ear protection.
9)
Do not remove metal chips with bare hands.
10) Do not touch the spindle and the cutter during work.
11) Tools must be fastened firmly. When a milling cutter is used, check before start
of work if tool holding screws are screwed tight.
12) It is not permitted to use blunt of damaged tools.
13) Do not use milling cutter without pilots, and arbors without ejection spring.
Do not touch or replace the tool with power source on
– while
electromagnetic base is being used.
14) Use tools recommended
in Operator’s Manual only.
15) After use, always clean drilling machine from metal chips and coolant.
16) Always unplug machine from power supply during any work on the machine.
17) Before each use the machine should be checked for the presence of damage
and the proper and consistent use. Check whether any of the parts are broken
and that all the parts are fastened properly. Make sure to maintain proper
conditions affecting work of the machine.
Drawing 1.
Examples how safety chain should be fastened..
