JEI SOLUTIONS LTD
MAGBEAST HM40
5.2 (20130122)
Operators manual for Drilling Machine Magbeast HM40
- 17 -
4.10 Cancelling clearance
The drive and the slider (1) can be slid up and down smoothly using the lever (3),
uncovering strip (2) and the drill body.
In order to cancel clearance, the regulation screws (4) and the counter nuts (5) must
be tightened in order to safeguard against loosening.
Clearance cancellation should be carried out as follows:
1. loosen screws (4) after undoing the nuts (5),
2. slide the slider up and down several times,
3. slide the slider to its lowerest position
4. tighten the screws located at the height of the slider,
5. slide the slider up,
6. tighten the remaining screws,
7. slide the slider up and down and if necessary, tighten or loosen screws at the height where
problems with moving the slider occur,
8. tighten counter nuts (5) when screw has been put into position (using a hexagonal key)
Please keep all recommendations.
