Jeep WRANGLER 2017, User Manual

Page: 72 / 292

— Seat Belt Reminder Warning Light
When the ignition switch is first turned to
ON/RUN, this light will turn on for four to
eight seconds as a bulb check. During the
bulb check, if the driver's or passenger seat
belt is unbuckled, a chime will sound. After
the bulb check or when driving, if the driver’s
seat belt remains unbuckled, the Seat Belt
Reminder Light will flash or remain on con-
tinuously and a chime will sound.
— Vehicle Security Warning Light —
If Equipped
This light will flash at a fast rate for approxi-
mately 15 seconds when the vehicle security
alarm is arming, and then will flash slowly
until the vehicle is disarmed.
Yellow Telltale Lights
— Low Fuel Warning Indicator Light
When the fuel level reaches approximately
2.8 gal (10.6 L), this light will turn on and a
single chime will sound.
— Anti-Lock Brake (ABS) Indicator
Light
This light monitors the Anti-Lock Brake Sys-
tem (ABS). The light will turn on when the
ignition switch is placed in the ON/RUN
position and may stay on for as long as four
seconds.
If the ABS light remains on or turns on while
driving, then the Anti-Lock portion of the
brake system is not functioning and service is
required. However, the conventional brake
system will continue to operate normally if
the brake warning light is not on.
If the ABS light is on, the brake system
should be serviced as soon as possible to
restore the benefits of Anti-Lock Brakes. If
the ABS light does not turn on when the
ignition switch is placed in the ON/RUN
position, have the light inspected by an au-
thorized dealer.
— Malfunction Warning Light
The vehicle Check/Malfunction Indicator
Light (MIL) is a part of an Onboard Diagnostic
System called OBD II that monitors emis-
sions control systems. The light will illumi-
nate when the ignition is in the ON position
before vehicle start up. If the bulb does not
come on when placing the ignition in the
ON/RUN
position, have the condition
checked promptly.
Certain conditions, such as a loose or missing
gas cap, poor quality fuel, etc., may illumi-
nate the light after vehicle start. The vehicle
should be serviced if the light stays on
through several typical driving styles. In most
situations, the vehicle will drive normally and
will not require towing.
When the vehicle is running, the MIL may
flash to alert serious conditions that could
lead to immediate loss of power or severe
catalytic converter damage. The vehicle
should be serviced as soon as possible if this
occurs.
GETTING
TO
KNOW
YOUR
INSTRUMENT
P
ANEL
70