Jeep Wrangler 1997, Manual

Page: 888 / 1152

REAR VIEW MIRROR
REMOVAL
(1) Loosen the mirror set screw.
(2) Slide the mirror up and off the support button
(bracket) (Fig. 71).
INSTALLATION
(1) Slide the mirror onto the support button
(bracket).
CAUTION: Do not over-tighten the setscrew
because glass chipping and/or breakage could
result.
(2) Tighten the mirror setscrew to 1 N·m (9 in.
lbs.) torque.
REARVIEW MIRROR SUPPORT BRACKET
INSTALLATION
(1) Mark the position for the mirror bracket on the
outside of the windshield glass with a wax pencil.
(2) Clean the bracket contact area on the glass.
Use a mild powdered cleanser on a cloth saturated
with isopropyl (rubbing) alcohol. Finally, clean the
glass with a paper towel dampened with alcohol.
(3) Sand the surface on the support bracket with
fine grit-sandpaper. Wipe the bracket surface clean
with a paper towel.
(4) Apply accelerator to the surface on the bracket
according to the following instructions:
•
Crush the vial to saturate the felt applicator.
•
Remove the paper sleeve.
•
Apply accelerator to the contact surface on the
bracket.
•
Allow the accelerator to dry for five minutes.
•
Do not touch the bracket contact surface after
the accelerator has been applied.
(5) Apply adhesive accelerator to the bracket con-
tact surface on the windshield glass. Allow the accel-
erator to dry for one minute. Do not touch the glass
contact
surface after the accelerator has been
applied.
(6) Install the bracket according to the following
instructions:
•
Apply one drop of adhesive at the center of the
bracket contact-surface on the windshield glass.
•
Apply an even coat of adhesive to the contact
surface on the bracket.
•
Align the bracket with the marked position on
the windshield glass.
•
Press and hold the bracket in place for at least
one minute.
NOTE: Verify that the mirror support bracket is cor-
rectly aligned, because the adhesive will cure rap-
idly.
(7) Allow the adhesive to cure for 8-10 minutes.
Remove any excess adhesive with an alcohol-damp-
ened cloth.
(8) Allow the adhesive to cure for an additional
8-10 minutes before installing the mirror.
SUNVISOR
REMOVAL
(1) Remove the screws that attach the sunvisor
arm support brackets to the windshield frame (Fig.
72).
(2) Remove the sunvisor from the windshield
frame
INSTALLATION
(1) Position the sunvisor on the windshield frame
and align the arm support bracket holes with the
frame.
Fig. 71 Rear View Mirror
Fig. 72 Sunvisor
23 - 42 BODY
TJ
REMOVAL AND INSTALLATION (Continued)