Jeep Wrangler 1997, Manual

Page: 1022 / 1152

(12) Loosen front band adjusting screw lock nut
(Fig. 72) 4-5 turns. Then tighten band adjusting
screw until band is tight around front clutch. This
prevents front/rear clutches from coming out with
pump and possibly damaging clutch or pump compo-
nents.
(13) Remove oil pump bolts.
(14) Thread bolts of Slide Hammer Tools C-3752
into threaded holes in pump body flange (Fig. 73).
(15) Bump slide hammer weights outward to
remove pump and reaction shaft support assembly
from case (Fig. 73).
(16) Loosen front band adjusting screw until band
is completely loose (Fig. 72).
(17) Squeeze front band together and remove band
strut (Fig. 74).
(18) Remove front and rear clutch units as an
assembly. Grasp input shaft, hold clutch units
together and remove them from case (Fig. 75).
(19) Lift front clutch off rear clutch (Fig. 76). Set
clutch units aside for overhaul.
(20) Remove output shaft thrust washer from out-
put shaft (or from rear clutch hub) (Fig. 77).
(21) Remove output shaft thrust plate and washer
from output shaft hub (Fig. 77).
(22) Remove front band from case (Fig. 78).
(23) Remove extension housing from transmission
case.
Fig. 75 Front/Rear Clutch Assemblies
Fig. 72 Front Band Adjusting Screw Lock Nut
Fig. 73 Oil Pump/Reaction Shaft Support
Fig. 74 Front Band Strut
21 - 116 TRANSMISSION AND TRANSFER CASE
TJ
DISASSEMBLY AND ASSEMBLY (Continued)