Jeep COMPASS 2018, Owner'S Manual

Page: 22 / 712

Skin oils may cause battery deterioration. If
you touch a battery, clean it with rubbing
alcohol.
4. To assemble the key fob case, snap the two
halves together.
Programming Additional Key Fobs
Programming the key fob may be performed by
your authorized dealer.
Request For Additional Key Fobs
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
WARNING!
•
Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
•
For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF mode.
Duplication of key fobs may be performed at
your authorized dealer. This procedure consists
of programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
NOTE:
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
your authorized dealer.
General Information
The following regulatory statement applies to all
radio frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
IGNITION SWITCH
Keyless Go — Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The START/STOP push button ignition has
three operating modes. The three modes are
OFF, ON/RUN, and START.
NOTE:
If the ignition state/mode does not change with
the push of a button, the key fob may have a low
or dead battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side (side opposite of the
emergency key) of the key fob against the
ENGINE START/STOP button and push to op-
erate the ignition.
The push button ignition can be placed in the
following modes:
OFF
•
The engine is stopped.
•
Some electrical devices (e.g. Central locking,
alarm, etc.) are still available.
START/STOP Ignition Button
19