Jeep COMPASS 2018, Owner'S Manual

Page: 175 / 712

•
The braking temperature exceeds normal
range (overheated).
•
The gear selector is removed from the DRIVE
position.
•
Manual transmission is not in a forward gear,
if equipped.
•
Manual transmission is in NEUTRAL or clutch
pressed down, if equipped.
•
The driver switches ESC to full-off mode.
To Resume Speed
To resume a previously set speed, push the
RES button and release. Resume can be used
at any speed above 19 mph (30 km/h).
To Turn Off
The system will turn off and erase the set speed
in memory if:
•
The Normal (Fixed Speed) Cruise Control
on/off button is pushed.
•
The ignition is turned OFF.
•
You engage Four-Wheel Drive Low.
•
The Adaptive Cruise Control (ACC) on/off
button is pushed.
PARKSENSE REAR PARK
ASSIST — IF EQUIPPED
The ParkSense Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver. Refer to “ParkSense System Usage
Precautions” for limitations of this system and
recommendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. The system will remain
active while in REVERSE until the vehicle speed
is increased to approximately 7 mph (11 km/h)
or above. While in REVERSE, and above the
system’s operating speed, a warning will appear
within the instrument cluster display indicating
the vehicle speed is too fast. The system will
become active again when the vehicle speed is
decreased to speeds less than approximately
6 mph (9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors’ field of view. The
sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches
(200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.
ParkSense Warning Display
The ParkSense Warning screen will only be
displayed if “Sound and Display” is selected
from the Customer - Programmable Features
section of the Uconnect System. Refer to
" Uconnect Settings” in “Multimedia” for further
information.
The ParkSense Warning screen is located
within the instrument cluster display. It provides
visual warnings to indicate the distance between
the rear fascia/bumper and the detected ob-
stacle. Refer to “Instrument Cluster Display” in
“Getting To Know Your Instrument Panel” for
further information.
ParkSense Display
When the vehicle is in REVERSE, the instru-
ment cluster display will show the park assist
ready system status.
The system will indicate a detected obstacle by
showing a single arc in one or more regions
based on the obstacle’s distance and location
relative to the vehicle.
If an obstacle is detected in the center rear
region, the display will show a single solid arc in
the center rear region As the vehicle moves
closer to the obstacle, the display will show the
single arc moving closer to the vehicle and the
audible chime increases as the objects gets
close to the vehicle.
If an obstacle is detected in the left and /or right
rear region, the display will show a single flash-
ing arc in the left and/or right rear region As the
vehicle moves closer to the obstacle, the display
will show the single arc moving closer to the
vehicle and the audible chime increases as the
objects gets close to the vehicle.
172