Jeep COMPASS 2018, Owner'S Manual

Page: 199 / 712

•
If a parking maneuver is being carried out
between two parked vehicles alongside the
pavement, the system may cause the vehicle
to mount the pavement.
•
Some maneuvers at very tight bends might
be impossible to be carried out.
•
Take great care to ensure that conditions do
not change during the parking maneuver (e.g.
if there are persons and/or animals in the
parking place, moving vehicles, etc.) and
intervene immediately if necessary.
•
During parking maneuvers, pay attention to
vehicles approaching from the opposite direc-
tion. Always abide by the law and road
regulations.
NOTE:
•
Correct system operation is not guaranteed if
snow chains or the space-saver wheel are
fitted.
•
The function only informs the driver about the
last appropriate parking place (parallel or per-
pendicular) detected by the parking sensors.
•
Some messages displayed are accompanied
by acoustic warnings.
LANESENSE — IF EQUIPPED
LaneSense Operation
The LaneSense system is operational at speeds
above 37 mph (60 km/h) and below 112 mph
(180 km/h). The LaneSense system uses a
forward looking camera to detect lane markings
and measure vehicle position within the lane
boundaries.
When both lane markings are detected and the
driver unintentionally drifts out of the lane (no
turn signal applied), the LaneSense system
provides a haptic warning in the form of torque
applied to the steering wheel, as well as a visual
warning in the instrument cluster display, to
prompt the driver to remain within the lane
boundaries.
The driver may manually override the haptic
warning by applying torque into the steering
wheel at any time.
When only a single lane marking is detected and
the driver unintentionally drifts across the lane
marking (no turn signal applied), the LaneSense
system provides a visual warning through the
instrument cluster display to prompt the driver to
remain within the lane. When only a single lane
marking is detected, a haptic (torque) warning
will not be provided.
NOTE:
When operating conditions have been met, the
LaneSense system will monitor if the driver’s
hands are on the steering wheel and provide an
audible and visual warning to the driver when
the driver’s hands are not detected on the
steering wheel. The system will cancel if the
driver does not return their hands to the wheel.
Turning LaneSense On Or Off
The default status of LaneSense is “Off”.
The LaneSense button is located on the switch
panel below the Uconnect display.
To turn the LaneSense system on, push the
LaneSense button to turn the system on (LED
turns off). A “Lane Sense On” message is shown
in the instrument cluster display.
LaneSense Warning Button
Lane Sense On Message
196