JCM Part No. 960-000076R_Rev. 1
© 2007, JCM-American Corporation
A - 1 0
Appendix A
World Bill Acceptor (WBA®-1x/2x -SS & SS2)
Troubleshooting
3. Connect the data harness to the WBA-1X and
turn the DT-004
“ON”
. The following conditions
will occur:
• The
Power
and
Ready
lights on the DT-004
will illuminate
• The LEDs on the WBA-1X CPU will begin
too flash alternately
4. Press
“
Start
”
; the
Ready
light will begin to
flash indicating a download is in progress.
• The
OK
light will then illuminate and the DT-
004 will announce a beep when the download
is complete
• To verify download completion, press
Reset
and
Version.
DT-104 Downloading
Perform the following steps to initiate a DT-104
Download:
1. Connect the data cable to the WBA-1X.
2. Insert the proper Master EPROM into the DT-104
socket.
3. Power on the DT-104 (Part No. 701-000141R).
4. Scroll the screen to view
“
SETUP
”
and verify the
correct download speed – change if needed.
5. Ensure multi-mode is
“
OFF
”.
6. Press the Menu Button until
“
Program Menu
”
is
displayed. One of the following conditions will
occur:
• If the CPU LED lights on the WBA-1X are
alternating
–
Press
“
GO
”
• If no error
“
Device Ready
”
will be displayed
–
Press
”
Start
”
• The WBA-1X will show a download LED
sequence on the CPU LEDs
• The display panel on the DT-104 will count-
down from the highest memory location and
“
Download Successful
”
will display on the
panel when the download is successfully
completed.
PC Downloading
Perform the following steps to initiate a PC
Download:
1. Load PC Download program
DOWNLOAD PRO-
GRAM.EXE
and the corresponding Validator data
file into a common PC Directory (i.e., Folder).
2. Connect the Validator to a PC “Comm Port” using
the 9-Pin Cable connected to the PS15-006 Power
Supply.
3. Set the DIP Switches for the appropriate down-
load speed.
4. Connect the Power Supply to the Validator.
5. Run
DOWNLOAD PROGRAM.EXE
.
6. Use the
BROWSE
function to select the program
data file to be loaded into the WBA.
7. Select the download speed to match the DIP
Switch setting of the WBA.
8. Press
“
Start Download”
.
9.
When the download is complete,
“
Download
Successful”
will display on the PC Screen.
NOTE: If the version between the EPROM
and the WBA-1X verify, the
“OK”
LED will
light.
NOTE: The two LEDs on the WBA Processor
board should be alternately flashing.
NOTE: The WBA/DBV200 Download
Application is available on the JCM Web
Site using the Product Support/Software/
Software Applications pull down menu
(http://www.jcm-american.com/products/
software/apps.asp).
