JCM Part No. 960-000076R_Rev. 1
© 2007, JCM-American Corporation
1 - 2
Section 1
World Bill Acceptor (WBA®-1x/2x-SS & SS2)
General Information
Model Number Specifications
Precautions
The Figure 1-2 symbols are defined as follows:
1. (
Type 1
) Do not insert a torn, folded, or wet
bill, as this action may cause a bill jam inside
the unit.
2. (
Type 2
) Do not expose the unit to water.
The unit contains several precision elec-
tronic devices which can be damaged if
water or any liquid is sprayed or spilled into
the unit.
3. (
Type 3
) Do not install the unit into a dusty
environment. Dust may affect and degrade
the sensor’s performance.
User Cautions
1. Be sure to turn the power off before plugging
or unplugging connectors.
2. Firmly close the unit’s Transport path before
applying power.
3. When closing the unit, ensure all service
door locks click into place. Make sure to
open and close the unit’s bill path access
ports gently, and take care that no dust or
other foreign objects enter when opening the
guide area.
4. Do not allow inventory stock to endure high
temperature, high humidity or a dusty
environment.
5. Do not throw the unit or allow it to fall to the
ground. Improper handling may cause per-
sonal injury and/or damage to the equipment.
6. If the bill validator is dirty due to dust,
foreign objects, or other such debris adhering
to it, the bill acceptance rate will degrade.
Use a soft, lint-free cloth and a mild non-
abrasive soap and water solution to clean
dust and debris from the bill path.
Table 1-1
Model Number Specifications
N
o
Model: WBA - ** - SS* - ***(*) - *** - **
N
o
(1)(2) (3) (4)(5) (6,7,8) (9)
(1) Acceptor head type
1. 1x Head (magnetic sensors enhanced)
2. 2x Head (optical sensors enhanced)
(2) CPU
board
type
(3) Box type
SS = SS Down Stacker (80mm width)
SS2 = SS Down Stacker (82mm width for Euro
Banknotes)
(4) Country Code
Refer to Table 1-6 on page 7
(5) Denominations accepted
Relative to the Country Code programmed
(Euro Examples)
(6) Box capacity
4 = 400 note capacity
5 = 500 note capacity (standard)
A = 1000 note capacity
(7) Faceplate
*
0 = Without Faceplate (standard)
1 = With JCM standard WBA Faceplate (85mm wide)
*. Contact your JCM Sales Representative for information concerning
Faceplates, and other options available.
(8) Guide Width
(9) External Interface
†
01 = ID001: Parallel Interface
02 = ID002: Pulse Interface
03 = ID003: Bidirectional Serial Interface (standard)
44 = ID044/045: Serial & Pulse Interface
0A2 = ID-0A2: Serial & Pulse Selectable Interface
†. Contact JCM for other Interface requirements.
0. 1Mbit Flash ROM
1. 1Mbit EPROM
2&4. 4Mbit Flash ROM
3&5. 4Mbit EPROM
Denomination
Country Code
€5 €10 €20 €50 €100 €200 €500
EUR1
X
X
X
EUR2
X
X
X
X
EUR3
X
X
X
X
X
EUR4
X
X
X
X
X
X
EUR5
X
X
X
X
X
X
X
1 = 66mm
2 = 70mm
3 = 75mm
4 = 80mm
5 = 82mm
Type 1
Type 2
Type 3
Figure 1-2
Precautionary Symbols
Do NOT carry the WBA unit by the
Cash Box handle, it can release and
drop the unit to the ground causing
housing damage.
Under no circumstances allow the cloth
to be wet enough to allow excess fluid
to run into the device; internal printed
circuit boards may be damaged.
Do not use any alcohol, solvents or
scouring agents which can attack the
plastic surfaces of the device.