Installation and connections
Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables through the bottom of the
receiver. Connect the power cables to the terminals marked in the mother board, as indicated. Fix the receiver front to the
rear part using the screws supplied.
Operating
The pilot lights are activated every 5 seconds to indicate the correct supply of power to the equipment.
Upon receiving a code, the receiver checks whether it is in its memory, activating the corresponding relay. The relay activ-
ation mode is selected in either impulse or ON/OFF using the Imp/Bies jumper (only with the relay 2).
Programming
Manual programming
Press the receiver programming button for 1 sec. and an acoustic signal will be heard. The receiver will enter standard pro-
gramming (see table). If the receiver programming button is held pressed down, the receiver will enter special programming,
cyclically passing from one configuration to the next. Once the programming configuration for the transmitter to be registered
has been chosen, send the code to be programmed by pressing the transmitter. Every time a transmitter is programmed, the
receiver will issue an acoustic signal for 0.5 sec. After 10 seconds without programming or pressing the first two transmitter
buttons, the receiver will exit programming mode, issuing two acoustic signals of 1 sec. If upon programming a transmitter the
receiver memory is full, it will issue 7 acoustic signals of 0.5 sec. and exit programming.
Configuration of transmitter programming in the receiver
Led R1
Led R1
Standard Programming
(default option, the receiver is always configured on pluri-channel)
The relays are activated 1st relay by channel 1 and 2nd relay by channel 2
(3rd relay by channel 1 and 4th relay by channel 2)
Flashing
Flashing
Special programming
By pressing any transmitter channel, relay 1 on the receiver will be activ-
ated
ON
OFF
By pressing any transmitter channel, relay 2 on the receiver will be activ-
ated
OFF
ON
By pressing any transmitter channel, the two relays will be activated at the
same time*
ON
ON
* If working in ON/OFF activation mode, relay 1 will act as impulse and relay 2 as ON/OFF.
Therefore, on the first press relay 1 will close and open the contact and relay 2 will only close. On
the second, relay 1 will close and open the contact and relay 2 will open.
Note: Each transmitter can be configured
independently on the receiver.
jcm
technologies
5