JCM GLOBAL Taiko PUB-7, Manual

Page: 10 / 20

Part No. 960-100919R_Rev. 1 © 2017 JCM American Corporation
1 0
March, 2017 JCM Training Overview Taiko™ Banknote Validator
Lecture Notes
Test No. 1 - Transport Motor Forward Rotation Test
To perform Diagnostic Test #1, proceed as follows:
1. Set DIP Switch #1 ON, and apply power to the Taiko
™
Unit.
2. Set DIP Switch #1 OFF.
The following indications will occur:
• If the BLUE LED begins Flashing, the Forward Motor rotational speed is cor-
rect.
• If the RED LED is flashing, the Forward Motor speed is either too fast, or too
slow.
• Set DIP Switch #1 to ON to stop the Forward Motor Rotational Test.
Test No. 2 - Transport Motor Reverse Rotation Test
To perform Diagnostic Test #2, proceed as follows:
1. Set DIP Switch #1 and #2 ON, and apply power to the Taiko
™
Unit.
2. Set DIP Switch #1 OFF.
The following indications will occur:
• If the BLUE LED begins Flashing, the Reverse Motor rotational speed is cor-
rect.
• If the RED LED is flashing, the Reverse Motor speed is either too fast, or too
slow.
Set DIP Switch #1 to ON to stop the Reverse Motor Rotational Test.
Test No. 3 - Aging Test
To perform Diagnostic Test #3, proceed as follows:
1. Set DIP Switch #1, #2 and #4 to ON, and apply power to the Taiko
™
Unit.
2. Set DIP Switch #1 OFF.
The following indications will occur:
• The motor will cyclically rotate forward and reverse. The cycle will repeat until
the test is stopped or an error occurs.
• The BLUE LED will be lit steady. If an error occurs, the Bezel LED will flash
an error code. See Table 4 on page 11 for a list of Aging Test Error Conditions.