![background image](http://html1.mh-extra.com/html/jcm-global/ivizion-series/ivizion-series_operation-and-maintenance-manual_3543287051.webp)
P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
4 - 3
Disassembly/Reassembly
iVIZION® Series Next-Generation Banknote Acceptor Unit
Section 4
11. Remove the two (2) Timing Belts (See Figure 4-8
a
1
& a
2
) from the Transport Unit.
Home Position Sensor Board/Home
Position Sensor, FFC & Interface
Connector Board Removals
To remove the Home Position Sensor Board, the
Home Position Sensor FFC and the Interface
Connector Board proceed as follows:
1. Remove the Transport Unit from the
iVIZION
®
Unit.
2. Remove the Validation Section from the Trans-
port Unit.
3. Remove the two (2) TR Cover mounting Screws
1
& a
2
) from the bottom of the
Transport Unit, and remove the Transport (TR)
Bottom Cover (See Figure 4-9 b) off the Trans-
port Unit.
4. Use a small Screwdriver to release the five (5)
Click-tab Stops of TR Side Cover “A” (See Fig-
1
through a
5
), and remove TR Side
Cover “A” (See Figure 4-10 b) from the Transport
Assembly.
5. Remove the two (2) mounting Screws (See Figure
4-11 a
1 &
a
2
) retaining the Home Position Sensor
Board in place (See Figure 4-11 b).
6. Remove the Home Position Sensor Board and the
Home Position Sensor FFC Assembly
(See Figure 4-11 c) from the Transport Unit.
7. Remove the three (3) mounting Screws
1
, d
2 &
d
3
) retaining the Inter-
face Connector Board in place (See Figure 4-11
f), and then remove the three (3) Flat Ribbon
Cables from the Interface Connector Board
1
, e
2 &
e
3
).
NOTE: When replacing the Frame Outer
“L” Assembly, ensure that the Plate Nut is
correctly re-positioned (See Figure 4-7 g).
Figure 4-8
Timing Belt Removal
a
1
a
2
b
NOTE: The Timing Belts should be
replaced as illustrated in Figure 4-8b when
reassembling the Unit. Be careful that the
Pulleys and/or Rollers do not accidentally
fall off during reassembly.
Figure 4-9
TR Bottom Cover Removal
a
1
a
2
b
Figure 4-10
TR Side Cover “A” Removal
a
1
a
2
a
4
a
5
a
3
b
NOTE: When the three (3) lower Click-tab
stops are difficult to remove from the top,
release them from bottom-side instead.
Figure 4-11
Home Position Sensor Board, Home
Position Sensor FFC Assembly and
Interface Connector Board Removals
a
2
a
1
b
c
d
3
d
2
d
1
e
1
e
2
e
3
f