24
21-18RT
Instruction & User Manual
8. Attach the base plate by tightening the screws.
9. Insert the collet cone and the trimmer bit into the
offset base, and then tighten the collet nut.
10. Insert the hex wrench into the hole of the offset
base, and then tighten the collet nut with the
wrench.
m
To remove the base, follow the installation
procedure in reverse.
Installing or removing the
plunge base
m
Optional accessory
1. Open the lock lever of the plunge base, then
insert the tool into the plunge base all the
way aligning the groove on the tool with the
protrusion on the plunge base.
You can also mount the belt to the pulley
without removing the base plate as shown in
the figure.
NOTE
2886 21-18RT 2886 21-18RT Brushless Router and Accessories Manual.indd 24
2886 21-18RT 2886 21-18RT Brushless Router and Accessories Manual.indd 24
13/09/2021 10:16
13/09/2021 10:16