©2019 JBT LEKTRO, INC. All rights reserved.
October 2019
4-9
CHAPTER 4: COMPONENTS & CONTROLS
> Release the switch when the strap reaches the desired length
CAUTION
CAUTION
THIS SWITCH OVERRIDES BOTH THE FENDER-MOUNTED CONTROL SWITCH
AND THE WINCH LIMIT SWITCH. DO NOT OVER-RETRACT THE WINCH.
•
Hydraulic Front Gate Switch (
not shown
;
if equipped)
:
This spring-loaded, three-position
toggle switch raises or lowers the Hydraulic Front Gate, as follows:
> Pushing and holding the switch up raises the Hydraulic Front Gate.
> Pushing and holding the switch down lowers the Hydraulic Front Gate.
> Release the switch when the Hydraulic Front Gate reaches the desired length.
•
CCTV Monitor (3;
optional
):
If equipped, displays video from the Cradle Camera located at
the front of the vehicle.
•
Battery Indicator Gauge (4;
optional
):
If equipped, indicates the battery charge status. Do
not use this gauge when the tractor is being charged, as it will read a full charge.
•
EVT1000 Drive Controller Dash Display (
5; B station is optional
):
If equipped, indicates
status codes and battery discharge from the EVT1000 Drive Controller.
> When the Motive Power Switch is turned ON, the gauge will display the percentage of
remaining battery power.
> If a fault occurs, the wrench LED will illuminate and the gauge will display a fault code.
•
Motor Overspeed Indicator Light (6):
Illuminates when the motor is running above its
maximum rated RPM.
•
Aircraft Protection System controls (7):
If equipped, this area will be configured as
appropriate for the installed Aircraft Protection System. See
CAUTION
CAUTION
EXCEEDING THE VEHICLE MAXIMUM SAFE DESIGN SPEED CAN DAMAGE THE
MOTOR. NEVER DRIVE THE VEHICLE FASTER THAN THE MAXIMUM SAFE
DESIGN SPEED.
AUTHORED BY ANTHONY HERNANDEZ - (415)786-2081 - [email protected]
