43
FNS-0002-060-EN January 2017 Rev F
Rebuilding (Continued)
13. Remove sleeve bearings from main frame.
Refer to Figures 33 and 34.
The outer upper drive shaft bearing can be removed using puller, 1-1/4" removal slug, and short
threaded removal rod.
The inner bearing can be removed the same way, or can be pressed out using driver. The lower
shaft bearing can be removed the same way except using 1" removal slug. New bearings can be
installed by compression (
Figure 35
) by using installation pilot, installation washer, and long
threaded installation rod. Light coat of Teflon grease can be used on outer diameter of bearings to
aid in installation.
14. There are thrust washers next to each bearing on the main frame. Make sure the old
ones have been removed and new ones installed.
One side of thrust washer is plain metal. Silicone this side and glue them to the frames
(Typical 4 places).
DO NOT
get silicone on surface of any bearing.
15. Before reassembling, check all shafts for excessive wear; replace as necessary.
Reassemble parts in the reverse order of removal.
DO NOT
forget to put keys back into crank
arms.
On both crank arms, be sure to tighten socket head cap screw first. And then the set screw.
Tighten fasteners to torques shown.
Lubricate all grease fittings if provided.
Figure 33. Removing Bearing from Lower Rotary Drive
Summary of Contents for FRESH'N SQUEEZE
