ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
5/41
GALAXY
3. DMX-mode:
When the units are connected in DMX-mode, they can be controlled using the DMX-chart:
OPERATE THE UNIT BY CA8 OR RF8SET
When used in standalone or master/slave mode we strongly advise
you to use the CA-8 “Wired easy controller” or RF-8SET “Wireless
easy controller”.
CA-8 wired remote:
Connect the controller to the jack input of
the first unit (master).
RF-8SET wireless remote:
the wireless remote has two parts:
RF-8T:
small RF-transmitter that can control up to 5 effects.
RF-8R:
small RF-receiver that should be connected to the
DIN 5-pin input of the GALAXY. See the installation manual
of the receiver for more information.
Now you can control all the connected units:
STANDBY BUTTON:
Press this button to start/stop blackout mode on all connected units.
MODE/FUNCTION BUTTONS:
With the MODE button you can select 3 different modes:
STAND BY
Blackout the unit
FUNCTION
Strobe
1. Synchronous strobe in
white
2. Sound strobe in white
3. Sound strobe in color
Select color
1.
Red
2.
Green
3.
Blue
4.
White
5.
Red + Green
6.
Red + Blue
7.
Red + White
8.
Green + Blue
9.
Green + White
10. Blue + White
11. Red + Green + Blue
12. Red + Green + White
13. Red + Blue + White
14. Green + Blue + White
15. Red + Green + Blue + White
16. Color change by sound
Select Show
1 – 6
MODE
Sound (LED OFF)
Manual Color (LED ON)
Show (LED slow blinking)
ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
6/41
GALAXY
MAINTENANCE
Make sure the area below the installation place is free from unwanted persons during servicing.
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
Clean with a soft cloth using normal glass cleaning products. Always dry the parts carefully.
Clean the external optics at least once every 30 days.
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
AC 100 - 240V, 50Hz/60Hz
Fuse:
250V T2A
Power consumption:
30 Watt
Sound Control:
Internal microphone
Lamp:
2x 10W RGBW LED
Size:
344 x 350 x 152mm
Weight:
5 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
