22
Rigging Manual
6.5 INSTALLING THE ACK1
STEPS:
• Remove the four bolts that were pre-installed into the threaded M10 nuts.
• Using the included hardware, place one split lock washer and then one washer onto each of the four bolts.
• Line up the caster and re-install the four bolts and washers through the caster holes.
• Repeat for the remaining three corners.
1
2
3
4
TOOLS REQUIRED:
An 8 mm Allen Key is required to install the ACK1 caster kit. Apply a torque value of 3.9 Nm (35 in-
lbs) and non-permanent thread lock.
1
2
3
