WALL ANCHOR GUIDELINE
WALL ANCHOR GUIDELINE
www.jaypro.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
© COPYRIGHT 2022 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 3 of 10
INNOVATION, PERFORMANCE AND COMMITMENT SINCE 1953
PRE-CAST CONCRETE WALLS
The Hilti Kwik bolt 3 comes in two varieties – Expansion anchor and Adhesive
anchor (sometimes referred to as a chemical anchor). The Hilti KWIK Bolt 3
is the only anchor approved in many California districts due to its endurance
under seismic loading. It has extremely high load capacities, but is has
particularly stringent preparation steps. Consult Hilti’s own website
(www.us.hilti.com) and installation instructions supplied with anchors for
complete site and equipment preparations. Shown below are general
steps for installation for reference only.
Hilti KWIK Bolt 3 (Expansion Anchor)
1.
Hammer drill a hole to the same nominal diameter as the KWIK Bolt 3.
The hole depth must exceed the anchor embedment by at least
one diameter. The fixture or predrilled wood plank may be used as
a template to ensure proper anchor location.
2.
Clean debris out of drilled hole.
3.
Drive the KWIK Bolt 3 into the hole using a hammer. The anchor
must be driven until at least six threads are below the surface of
the fixture (or wood).
4.
Tighten the nut to the recommended installation torque,
alternating anchors back an forth multiple times until the proper
torque requirements are met.
