Instruction Sheet
Models ATV-56, ATV-56B, ATV-56C & ATV-56BC
LUXOR
2245 Delany Road
Waukegan, IL 60087
Ph: 847/244-1800 • 1-800-323-4656
Fax: 847/244-1818 • 1-800-327-1698
1 - Top Stand Assembly
1 - Bottom Stand Assembly
1 - Rubber Mat
4 - 4˝ Casters, 2 w/brake
8 - Bolts
8 - Nuts
1 - Power Cord Assembly
With Hardware
For model ATV56C, ATV56BC
2 - Keys
2 - Chrome Recessed Handles
4 - Black Screws
Tools Required
1 - Slotted Screwdriver
1 - Rubber Mallet
Parts List
1.
Turn bottom stand assembly upside down on a smooth surface.
Push the four casters firmly into the caster socket holes in
bottom of each leg, as illustrated.
IMPORTANT: Casters must be fully seated. Tap firmly with a
rubber mallet properly seat casters. Turn the bottom stand right
side up.
2.
The big wheel is to be installed along the most narrow side of the
table. Install axle brackets as illustrated. Tap one axle cap onto
one end of the axle and slide the big wheel onto the axle from the
opposite end. Slide one washer onto axle so it rests against the
big wheel. Install axle by sliding it through axle brackets so that big
wheel is resting against side of bracket. Slide washer onto the
open side of the axle and then slide the remaining big wheel into
place.
Tap remaining axle cap onto axle end. Big wheels should be snug
fit with little side-to-side play. Push the two locking casters firmly
into the holes in the front of the cart. Important: Casters must be
fully seated. Tap firmly with rubber mallet.
For Big Wheel Models
3 Slots On Wheel Hub
Facing Inside
End
Cap
Axle
Axle
Bracket
8˝ Big
Wheel
Washer
Table Top
(Upside Down)
Table Illustrated
Upside Down
Bottom
Stand
Assembly
Back
Place Locking Casters
as Illustrated
Front
Axle Is
Being Held
Firmly In
Place
Use Hammer
To Tap Axle
Cap Into Place
ATV56
