QTY
DESCRIPTION
ITEM
2
M12 x 35mm HEX BOLT
B1
2
M12 x 65mm HEX BOLT
B2
2
M12 x 75mm HEX BOLT
B3
6
M12 HEX NUT
N1
12
M12 WASHER
W1
8
M12 PLASTIC WASHER
P1
ADJUSTABLE HEIGHT WALL MOUNT SYSTEM
WM-65 & WM-54
www.jayprosports.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
© COPYRIGHT JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 4 of 12
2022
B2
W1
P1
N1
W1
P1
W1
B2
NOTE WELD HOLES TO FACE DOWN WARDS
NOTE THIS END FRAME
PRE-INSTALLED PLASTIC WASHERS
1.
Unpack extension arms and mounting brackets.
2.
Align lower extension arm holes to outside holes of the frame flange.
Connect using the hardware two B2, four W1, two P1 and two N1. Another two plastics
washer P1 will be between the extension arm and the frame.
Note: DO NOT over tight. Snug tighten only.
3. Attach the upper extension arms and upper mounting brackets to the frame flange using
The hardware two B3, four W1, two P1 and two N1. Another two-plastic washer P1 will be
between the extension arm and the frame. They are factory attached.
4. Attach the lower mounting bracket to the frame using two B2, four W1, and two N1.
5. Attach upper mount of actuator assembly to the upper and lower mounting brackets using
one B5, two W2 and one N2.
6. Attach lower mount of actuator assembly to the lower extension arm using
One B4, two W2, two P2 and one N2
7. Tighten all extension arm bolts to extension arms and mounting brackets.
Tighten B2, but make sure free movement is maintained at the pivot point.
Note: Lower mounting brackets are shorter than the upper ones.
Frame Assembly
Note: the plastic washers P2 will be between
the actuator and mounting brackets.
DO NOT over tighten. Snug tighten only.