WALL ANCHOR GUIDELINE
WALL ANCHOR GUIDELINE
www.jaypro.com / (800) 243-0533 / 976 Hartford Tpke, Waterford, CT 06385 USA
SUBJECT TO CHANGES IN DESIGN AND MANUFACTURING
© COPYRIGHT 2022 JAYPRO SPORTS, LLC. ALL RIGHTS RESERVED
Sheet 5 of 10
INNOVATION, PERFORMANCE AND COMMITMENT SINCE 1953
Hilti HIT-HY 200 Adhesive Anchor Systems (HIT-Z Anchor Rod or HAS Threaded Rod)
Hilti offers numerous acceptable adhesive anchors for all applications. For maximum productivitiy, reliability and for
fast curing requirements, HIT-HY 200 with HIT-Z Anchor Rods or HAS Threaded Rods is recommended. See
applicable Hilti tables below for gel and cure time information. Remember to consult Hilti directly for complete
specifications and installation instructions. The information included herein is intended as a guide only for assistance
in proper anchor selection. HIT rod information shown but other acceptable anchors are available from Hilti.
1. Drill anchor hole with carbide bit. Contact Hilti for use of Diamond Core bits.
2. Clean hole with wire brush. Proper hole cleaning is essential.
3. Insert air nozzle to bottom of hole and blow out hole using a pump or compressed air.
4. Put refill pack into holder. Remove cap covering threaded projection.
5. Screw on static mixer.
6. Put holder/cartridge into appropriate dispenser and discard first two trigger pulls of adhesive from each refill pack
or cartridge.
7. Inject adhesive into hole starting at the bottom until 1/3 to 2/3 full. Use mixer filler tube extensions when needed to
reach the hole bottom.
8. Unlock dispenser.
9. Insert rod. Twist during installation.
10. Fastener may be adjusted during specified gel time.
11. Do not disturb anchor between specified working time
and cure time. See chart below.
12. Apply specified torque as required to secure items
to be fastened. Do not exceed maximum torque specified.
