Jayco Legacy Fifth Wheel 2009, Owner'S Manual

Page: 89 / 132

SECTION 8
CAMPING & OPERATING
77
The RV slide out system is controlled by a
master lockout control switch. Each individual
slide out room is controlled by its own
separately labeled control switch, a slide out
control box and slide out motor.
Figure 1 Typical exterior slide out room control box (and motor)
compartment
Master lockout switch
The power slide out system
is equipped with a master
lockout switch (labeled as
the “SO shut off switch”).
This safety lockout control
switch is typically located
behind an interior cabinet
door.
Do not remove the following
master lockout switch
operation instruction label:
Figure 3 Slide out ON\OFF switch must
Slide out room control switch
The slide out control switch automatically
alternates the direction of the individual slide
out room each time the switch is pressed
(extending or retracting the slide room).
Figure 4 Typical slide out room control switches
The label abbreviations refer to the position of
the individual slide out room in relation to the
entry door: ODS means “OFF door side” and
DS means “door side.”
To operate the slide out system press and
hold the master lock out switch (Fig. 2)
continuously with one hand, and momentarily
push the slide room control switch (Fig. 4) for
the slide out room you wish to extend (or
retract) with your other hand.
Slide out room control box
Generally speaking, the slide room control
boxes are located in the “Maxi” compartment,
an exterior compartment or an interior cabinet
door.
Figure 5 Typical slide room controller
If the slide room control box is located in an
exterior compartment, do not remove the
following label from the compartment area:
Figure 6 This is not a storage
Figure 2 Master
lockout switch