Section 8: Plumbing System
140
4.
Remove and bypass the water filter:
Full System Canister
water filter
(if so equipped):
Turn water valves off at the canister. Remove the canister lid, take the filter out of the
canister, then replace the lid and turn the water valves back on.
Bypass the cartridge water filter
(if equipped):
Use the clear plastic tube (supplied with RV) to bypass the water filter.
5.
Prepare a chlorine solution using 1/4 cup of household bleach (sodium hypochlorite
solution) to one gallon (3.785 liters) of water in a container. Prepare one gallon of
solution for every 15 gallons of tank capacity. This will result in a residual chlorine
concentration of 50 ppm in the water system.
If a 100-ppm concentration is required, use ½ cup of household bleach with one gallon
of water to prepare the chlorine solution. One gallon of the solution should be used for
each 15 gallons of tank capacity.
6.
Attach a short section of garden hose to the SANITIZE/
WINTERIZE inlet at the utility center.
DO NOT use your
fresh water hose for sanitizing.
7.
Insert the other end of the short hose into a container hold-
ing the chlorine solution from step 5.
8.
Turn the pump switch ON (red LED will light). The solu-
tion will be drawn into the fresh water tank. Turn the pump
OFF when solution has been drawn into the tank. To aid in
siphoning, set the container on a surface approximately (2)
feet off the ground. The drain valves must be turned OFF.
9.
Disconnect the short hose from the SANITIZE inlet.
Leave the colored valves in the SANITIZE position.
10.
Power Fill Water Tank:
Attach your fresh water hose to the CITY WATER CONNECTION inlet at the utility
center. Connect the other end of the hose to a pressurized water source. Turn the wa-
ter on and finish filling the water tank with fresh water.
DO NOT OVERFILL THE
TANK!
Use the LED indicators on the tank monitor inside the RV at the Command
Center panel to monitor water level in fresh water tank.
Siphon Fill Water Tank:
If there is no pressurized water source available, fresh water can be siphoned into the
water tank from an external container (bucket). Fresh water hose should be connected
to the SANITIZE inlet, other end of the hose placed in the bucket of water. Colored
valves should still be in SANITIZE position. Turn the pump ON and water will be
siphoned into the tank.
DO NOT OVERFILL THE TANK!
Use the LED indicators
on the tank monitor at the Command Center to monitor water level in fresh water tank.
11.
When the tank is full, turn off the water source. Disconnect the hose from the faucet/
spigot first. Then disconnect the hose from the utility center panel.
At this point the following conditions should be met:
NOTE:
Fresh water tank sizes vary by model. Contact your dealer or
Customer Service for your specific tank size.
Summary of Contents for Eagle FW 2021
