Jaycar Electronics DS-8704HI-S, User Manual

Page: 77 / 136

77
interface.
The whole screen is divided into 22*18 panes (NTSC: 22*15). There is one yellow
panel on the upper left side. The motion area setup steps are the same as that of mask
area setup (refer to chapter 5.6). The only differences are that you can use [ PTZ ] key to
set the whole screen as motion area, and multi motion areas can be defined. Press [ A ]
key to clear all motion areas.
Setup multi areas: After you setup one motion area, press [ EDIT ] key, the yellow
pane will appear again, then you can setup another motion area.
Clear motion area:
Clear part of motion area: Move the yellow pane to the start clear position of motion
area, press [ EDIT ] , you will find the yellow pane is turned into black pane. You can use [
↓
]
[
→
] key to enlarge or shrink the black area. Press [ EDIT ] key to clear this part motion
area.
Press [ Enter ]
key to save and return “Image” menu. Press
[ ESC ] to cancel.
Clear all motion areas: Press [ A ] key to clear all motion areas of this channel.
The keys used to setup motion areas are following:

[
↑
] [
↓
] [
←
] [
→
] : Move yellow panel to any position;

[ EDIT ] :Yellow panel and red panel switch key:;

[
→
] : Right enlarge red pane;