Page 32 / 41
Ref doc :
330740F/EN
revision 01
29.09.2015
8.3.4 Procedure for « validation of an electronic key ».
Reminder :
To use the RADIOSAFE radio remote control system, the identity code contained in the transmitter memory
must
be
identical to the identity code of the electronic key, which is itself identical to that of the receiver.
If a maintenance transmitter is used or an electronic key is changed, you must copy the information contained in
the electronic key to the transmitter memory.
Condition for using this procedure :
The maintenance transmitter buttons must be configured identically to that described in the electronic key (or in the
original transmitter).
1-
Switch off the receiver
2-
Insert the electronic key in the transmitter.
3-
- Push and hold buttons B2 and "
On”,
- Unlock the emergency stop palmswitch on the transmitter (Fig.1),
- Wait until the orange indicator goes off before releasing buttons B2 and "On".
The two indicator lights on the transmitter (URE) flash rapidly.
4-
Press the ON button to automatically program the identity code : the two indicator lights on the transmitter go
off (Fig.2). The « identity code » information is copied from the electronic key to the transmitter memory.
5-
Exit the programming mode by pressing the emergency stop palmswitch (Fig.4).
With a new key, the transmitter and receiver may not communicate. Check that the
frequency channel has not been changed. If this is the case, refer to the previous chapter
covering the “Procedure for programming frequency”. In this respect, each new key is
supplied set for channel 01, i.e. frequency of 433.100 MHZ.
