Configuration
Configuring the Internal/External UHF Modem/GSM Module
Configuring the GSM module for Internet access
50
www.javad.com
Figure 3-5. Master/Slave tab
3. Click Apply, and then click File
Disconnect.
4. If needed, launch TriVU and set up the receiver to run as an RTK Base station.
3.1.3. Configuring the GSM module for Internet access
Note:
To comply with RF exposure requirements, maintain at least 20 cm between the user and the
GSM modem.
1. On the General tab, set the following parameters (Table 3-4) and click Apply (Figure 3-6
on page 51). In this tab modem and service status and possible errors are displayed.
Table 3-4. Receiver Parameters for the General Tab
Parameter
Base Receiver
Rover Receiver
Mode
GPRS
PIN
Enter a Personal Identification Number (PIN) if required.
Summary of Contents for TRIUMPH-1
