12
CONTROLS
Side view Jasic MIG 200CS
1.
Wire inch button: Pressing this button activates the feed motor which in turn pushes the welding wire
through the MIG torch and tip
2.
Gas purge button: Pressing this button activates the gas solenoid which in turn activates the gas flow
allowing you to correctly set the gas flow on the gas regulator
3.
Wire spool holder and tensioner: Allows a 5Kg (200mm dia) reel of wire to be located in place via an
alignment pin and then locked in place with the locking nut. The spool holder also has a brake
arrangement to ensure correct tension of the wire, this is done by turning the central bolt with an
Allen key clockwise (to tighten) or anti clockwise (to loosen)
4.
Inlet wire guide: The welding wire is fed through the inlet guide prior to feeding through the drive
rollers
5.
Wire feed roller and retaining nut: Secures and holds the grooved drive roller in place
6.
Outlet feed adaptor: Part of the Euro outlet connector which contains the inner outlet guide which
ensures smooth wire feed from the drive assembly through to the MIG torch
7.
Pressure roll assembly: Holds the upper drive roll in place which applies pressure to the welding wire
onto the grooved drive roller
8.
Drive roll tensioner: Allows the correct amount of tension to be applied to the top roller to ensure
good feed of the wire through the MIG torch
