23
NAVIGATING THE ‘LCD’ CONTROL PANEL
System Setting
-
Selection and Adjusting
Sleep Time Adjustment Option
Standby time is a function that when there is no operator activity with the Jasic TIG machine, then after
a pre
-
determined time (Factory time: 5 minutes) the machine will go into standby (sleep) mode.
To enter the standby sleep timer mode function screen, rotate the control dial to select the said icon
(as shown directly below) and press control dial button to access the control.
Here you can select the standby sleep time by rotating the control dial which will scroll through the
standby sleep time options of 0, 5, 10 and 15 minutes.
(The Factory default setting is 5 minutes and 0 means the standby time function is switched off).
Pressing the control dial button will confirm and save your choice and return you to the previous screen.
The standby sleep time function is only active in MIG and TIG mode (if activated).
If the machine is not used within the preset period of time (5 minutes for example), the machine will
then enter a standby state where the unit powers down and the screen will show just the Jasic logo
only.
The machine will wake up immediately and the screen show the previous data when either the torch
trigger, remote device or if one of the control panel buttons are pressed.
Overvoltage & Undervoltage Protection Switch
To enter the input voltage protection switch control function screen, rotate the control dial to select
the said icon (as shown directly above) and press control dial button to access the control.
Here you can select either OFF or ON for input voltage protection by rotating the control dial and then
pressing the control dial button to confirm your choice.
This option is factory set to ON, please speak with Jasic technical before interfering with this setting.
Pressing the control dial button will confirm and save your
choice and return you to the previous screen
otherwise press the return button to go back to the previous
screen.
