11
CONTROLS
Front view Jasic Cut 160
1. Digital ammeter, displays the preset and actual
current when cutting
2. Fault indicator: If this LED is on it indicates that
the temperature inside the machine is too high
and the machine is under overheating protection
status
3. Low gas indicator: If this LED is on it indicates
that the air supply is either not connected or is
set too low
4. Gas selector switch: This switch allows the user
to check and set the air setting for plasma and
secondary gas flow
5. 2T/4T torch trigger latch control: A useful function
when carrying out longer cuts, when cutting in 4T
mode you can remove your finger off the torch
trigger and the arc will remain on until you either
press the torch trigger again or you remove the
plasma arc away from the material being cut
6. Torch connector, the plasma torch connection (see page 13 for fitting instructions)
7. Pressure gauge: Used in conjunction with the pressure adjustor, this gauge allows you to accurately
set the required air pressure
8. Air pressure adjuster: This control know allows you to increase or decrease the required air pressure
to the desired pressure requirements
9. Current control: Allows the user to set the required current demand
10. Work return connector (35/50mm Socket)
Rear view Jasic Cut 160
11. Mains ON/OFF switch
12. Input air regulator
13. Cooling fan grill
14. Input power cable
15. Ground point
