13
INSTALLATION
Output connections
Plasma torch
The P150LT plasma torch supplied has the ‘euro style’
power/gas connection (in this case the gas used is
compressed air), pilot cable and switch pins
connections.
All plasma cutting system and torch incorporate a safety
circuit to prevent operator injury when changing
consumables etc. This is a simple ring circuit that breaks
the electrical torch switching as soon as the retaining
cap is removed preventing machine operation. Without such a protection
circuit as previously mentioned the open circuit voltage could be as high as
350V DC at the torch head.
The torch head encompasses the torch electrode, swirl ring for gas distribution
in the in the correct manner, cutting tip and retaining cap.
Fitting the P150LT plasma torch
On the Jasic Cut 160 plasma machine, the below torch fitting instructions will need to be observed.
Locate plasma torch plug into euro connector socket as shown in image (Fig 1) below
While using the key provided (Fig 6)
Push and hold in button in (Fig 2) whilst at the same time rotate nut on torch
clockwise until fully connected and tight as shown in Fig 3
Fig 4 shows the torch screwed in correctly
Fig 5 shows the torch not fully connected preset
Fig 6
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Push button
