3-23
(1) Ethernet Connector
Contents
Connect the user network via. PoE PSE
Interface
1000BASE-T, 100BASE-TX, 10BASE-T
Cable length
Maximum 100m.
In case of PoE HUB use
：
100m is from the WT to PoE HUB
In case of PoE injector use: 100m is from the WT via PoE injector to
HUB. (Because, there is no function of terminate PHY in the PoE
injector)
Connector shape
RJ-45
Pin assign
- ETHER signal: MDI-X
- POWER: IEEE802.3at Type2
Cable type
Ethernet cable for outdoor, STP(
Shield Twisted Pair
)
Range of applicable
outer
diameter
φ
4.0 mm - 7.0mm
(2) FG Terminal
Contents
Connect the ground wire.
Applicable Cable
Ground wire 1.6
□
(AWG#14)
Applicable terminal
FG terminal M6 nut.
Note
ground resistance is 100
Ω
or less
(3) Voltage Monitor Terminal For Receiving Level
Contents
It is a terminal monitoring a receiving level by using voltage circuit
tester.
・
When closing the Small lid, make sure that the rubber packing of the Small lid is free from
any foreign matter.
Summary of Contents for WIPAS2
