Japan Radio Co. WIPAS2, Instruction Manual

Page: 84 / 101

5-66
・
Please do not use the Ethernet cable out of application cable diameter (
φ
4.0mm to 7.0mm).
・
Please do not take the body (d) and the washer (e) off the small lid. If you take it off, you must
tighten it by torque 1.2 to 1.5N / m completely.
5.10. Waterproofing WT Small lid
Step1 Loosen the sealing nut (a) and remove the sealing nut (a), Clamping Claw (b), Sealing
Insert (c) and insert Ethernet cable (f) and attach an Ethernet plug (please be careful about
insertion direction).
Please do not take the body (d) and the washer (e) off the Small lid (g).
Applicable LAN cable diameter:
φ
4.0 mm to 7.0mm
Step2 The Ethernet cable connects with the Ethernet connector of the WT after passing through
the Small lid (g) (with the body (d) and the Washer (e)). ( figure 2 31).
Fix the Small lid to the WT and fit Sealing Insert (c), Clamping Claw (b) and Sealing nut (a)
The sealing nut is tightened by torque 1.2 to 1.5N/m.
When tightening the sealing nut (a) by hand, you must completely tighten it.
When using a tool (box wrench, spanner), you must tighten up 90 degrees (a quarter turn) from
the point that felt tightening load
Figure 5-47 Figure 5-48
Figure 5-46
Take off a sealing nut
(d)Body (e)Washer
(g)Small Lid
Waterproofing parts
(a) S
ealing nut
(f) Ethernet Cable
(c)Sealing Insert
、
(b) Clamping Claw
Connect Ethernet plug
Recommended tightening torque: 1.2
to 1.5N/m
(g) Small window Connect the Ethernet cable
(g) Small window
(a)Sealing nut
(b)Clamping Claw
(c)Sealing Insert