5-48
5.7. Adjusting the antenna Direction of the WT
5.7.1. Adjusting the Antenna Direction of the WT
This section describes the procedure for adjusting the antenna direction.
When adjusting the direction of the WT antenna, use the “Antenna direction adjustment tool”
together with Maintenance Tool.
Step 1: Connection between WT (master/slave) and Management Tool and display the Receiving
Level.
See Subsection 5.7.1.1
-
In case of near-distance installation (When receive level become more than -30dBm),
Enable the setting of the short distance mode.
Step 2: Rough adjustment for the WT (Master)
-
Install the Antenna direction adjustment tool.
-
See Subsection 5.7.1.2
-
Remove the Antenna direction adjustment tool.
-
When using the Antenna direction adjustment tool, See Subsection 5.7.1.3.
Step 3: Rough adjustment for the WT (Slave)
-
Install the Antenna direction adjustment tool.
-
See Subsection 5.7.1.2
-
Remove the Antenna direction adjustment tool.
-
When using the Antenna direction adjustment tool, See Subsection 5.7.1.3.
Step 4: Fine adjustment for the WT (Slave)
-
See Subsection 5.7.1.4
Step 5: Fine adjustment for the WT (Master)
-
See Subsection 5.7.1.4
Step 6: Verification
-
After fine adjustment, use the Management Tool to final check the receive level.
If the receive level value is within the standard range, the procedure for adjusting the
antenna direction has been completed.
If the receive level value is lower than a standard value, you need to perform Steps 4 and
5 again.
Step 7: Exit the Maintenance Tool
Summary of Contents for WIPAS2
