5-33
5.4. Configure the WT (slave)
Set the Slave configurations with the Maintenance Tool.
Step1 Select the Configuration
＞
Radio configuration tab
-
Operating Mode
：
Set the P-P(Slave)
-
Symbol Rate
：
Set 40MHz or 20MHz
-
Frame ID
：
Set the Frame ID same as a Master
（
1
〜
65535
）
-
Encryption Parameter
：
Set the Encryption Parameter same as a Master
(0-22 half width alphabet or digit character)
-
Click the
Setup
button. "Setup" makes configuration changes. These changes are
reflected after Reset.
-
Network Element Name
：
Set Network Element Name.
(0-20 full width or half width
alphabet)
-
FREQUENCY-CH: Set Fixed or SEARCH. If fixed, set Frequency CH. If SEARCH, set
start CH and end CH.
You should register the Frequency CH beforehand on “Frequency Setting” screen.
Configuration> “Frequency Setting” screen.
-
MTPC: Set MTPC (manual transmit power control) Level (-6 - +14dBm).
If Master is selected ATPC, Slave is automatically configured as ATPC Mode.
-
Click the
Setup
button.
Figure 5-6 Radio configuration tab (Slave)
Summary of Contents for WIPAS2
