Janus 250 Series, Owner'S Handbook Manual

Page: 79 / 96

79
LIGHTING: HEADLIGHT
HEADLIGHT
(see left)
Your Janus is equipped with a headlight that uses a 12 volt 60/55w H4 bulb.
WARNING: The bulb and lens become hot during operation. Always allow sufficient time
for the headlight to cool before servicing.
HEADLIGHT BULB REPLACEMENT
(see lower left):
1. Disconnect the battery negative (black) lead first.
2. Loosen the headlight bezel screw, located below the lens.
3. Carefully remove the headlight bezel by slipping it over the headlight bucket lip and lens.
4. Pull out the lens and unplug it from the headlight electrical harness.
5. Remove the wire clips at the back of the lens.
6. Gently pull out the light bulb and replace with a new bulb.
NOTE: Never touch the lightbulb with bare skin as the oil in your skin can damage the bulb.
WARNING: Do not reconnect battery until the headlight has been completely reassembled.
WARNING: Always replace with the correct bulb specified above. Operation with an
incorrect bulb can under or over-load the electrical system, leading to electrical failure,
loss of control, and an accident.
LED OPTION:
LED bulb replacement is the same as halogen bulb replacement except
that care must be taken that the bulb cooling fan does not pinch the wiring in the headlight.
Only use LED replacements available from Janus Motorcycles.