Janus 250 Series, Owner'S Handbook Manual

Page: 22 / 96

22
LEFT HANDLEBAR CONTROLS
4. TURN INDICATOR SWITCH
When the turn indicator switch is pushed to left or right, the respective
turn signal light flashes on and off. The turn indicator is canceled by
pressing in on the switch.
WARNING: Failing to cancel the turn indictor after a turn is
dangerous and may lead to an accident as other motorists may turn
or pull out in front of you. Always check that your turn indicator is
cancelled (pressing in on the switch) after executing a turn.
5. HIGH/LOW BEAM
Pressing this positive stop button switches between high beam and
low beam. A blue light will illuminate on the switch when the high
beam is on.
6. LIGHTING CONTROL SWITCH
This switch can be used to turn off all lighting (except instruments):
H: HEADLIGHT
•
P: PARKING
•
O: OFF
This will also function as an engine off switch. The bike will only start
and run in the H (Headlight position).
NOTE: Do not leave the bike with the light control switch in the
“O” (OFF) or “P” (PARK) position while the ignition key is ON
for any period longer than necessary, as it will drain the battery.
Always remove the key when parking the motorcycle.
1. ENGINE STOP SWITCH
In addition to the ignition key switch, the engine can be stopped by
pulling the engine OFF trigger located at the the front of the left
handlebar switch.
2. HORN BUTTON
Press the button to sound the horn.
3. CLUTCH LEVER
Pulling the clutch lever disengages the clutch, and vice versa.
1.
2.
3.
4.
5.
6.