26
MC200E
Adjusting the X-motor Gear
1. Remove the face cover, bed cover and front
cover (do not disconnect the connectors).
2. Remove the carriage unit (refer to page 21).
3. Turn the power switch on and press the lettering
key and select gothic font.
Enter 3 large “A”s and press the OK key.
4. Insert a piece of paper between the tension disks
to unable the thread sensorand lower the presser
foot.
5. Run the machine and loosen the setscrew. While
the carriage is moving in the direction of the
arrow, adjust the X-motor position so the gear
noise is lowest and tighten the setscrew.
6. Stop the machine. Attach the carriage unit, front
cover, bed cover and face cover.
7. Press the home position key to move the carriage
to the home position.
8. Turn the power switch off and remove the piece
of paper.
If the machine is noisy when sewing an embroidery design, adjust the X-motor gear as
follows.
Home position key
Piece of paper
Setscrew
Y-motor
Carriage
movement
Setscrew
Summary of Contents for MC230E
Page 1: ...MC230E...
