15
MC200E
Adjusting the Height of the Emboidery Foot
Space between the needle plate and bottom of the embroidery foot should be 1.0 to 1.3 mm
when the presser bar is at the lowest position.
1. Remove theface cover, bed cover and front cover.
2. Lower the presser foot lifter. Turn the hand wheel
until the presser foot reaches the lowest position.
3. Loosen the setscrew and move the presser bar
up or down to adjust the height of the embroidery
foot.
4. Tighten the setscrew. Make sure not to turn the
presser bar.
6. Attach the front cover, bed cover and face cover.
Setscrew
Presser bar
Presser foot lifter
Embroidery foot
1.0 to 1.3 mm
Needle
Summary of Contents for MC230E
Page 1: ...MC230E...
