Copyright & disclaimer
This product is approved for use in Europe and Australia/New Zealand and conforms to the
following standards:
•
EN55103-1
•
EN55103-2
•
EN60950
Conformance has been achieved for intended usage in environment E1: Residential.
To ensure continued compliance with EMC Directive 89/336 and the Australian Radio
communications Act 1992, use only high quality data cables with continuous shield, and connectors
with conductive back shells. Examples of such cables are: DMX: Belden 8102 (100% Aluminium foil
screen, 65% Copper braid).
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not properly installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
reorient or relocate the receiving antenna;
•
increase the separation between the equipment and receiver;
•
connect the equipment into an outlet on a different circuit from that to which the
receiver is connected;
•
consult the dealer or an experienced radio/television technician for help.
Disclaimer
Information contained in this manual is subject to change without notice and does not represent a
commitment on the part of the vendor. Jands Pty Limited shall not be liable for any loss or damage
whatsoever arising from the use of information or any error contained in this manual. It is
recommended that all service and repairs on this product be carried out by Jands Pty Limited or its
authorised service agents. Jands Pty Limited cannot accept any liability whatsoever for any loss or
damage caused by service, maintenance or repair by unauthorised personnel, or by use other than
that intended by the manufacturer.
Jands lighting products must only be used for the purpose they were intended by the manufacturer
and in conjunction with the user manual. Disconnect mains power when not in use.
Copyright JANDS PTY LIMITED 2014 All rights reserved.
Designed in Australia by:
JANDS Pty Limited ACN 001 187 837
Locked Bag 15 (40 Kent Rd) MASCOT NSW 1460 Sydney
Australia
Phone: +61-2-9582-0909
Fax:
+61-2-9582-0999
Web:
www.jands.com
Version 1.4
#ZMA6004
10 October 2014
