White w/Green Stripe
Orange w/White Stripe
Green w/White Stripe
White w/Orange Stripe
Orange w/White Stripe
Orange w/White Stripe
Green w/White Stripe
White w/Orange Stripe
Green w/White Stripe
White w/Orange Stripe
Green w/White Stripe
Green w/White Stripe
White w/Orange Stripe
White w/Orange Stripe
White w/Blue Stripe
+
White w/Blue Stripe
+
Blue w/White Stripe
–
Blue w/White Stripe
–
Use hand tools ONLY
If installing the 3 Louver AirBlaster proceed to Step 40.
If installing the 4 Louver AirBlaster skip to Step 44.
3 Louver Adjustment:
• Identify your target area and desired velocity
• Using hand tools loosen louver bolts enough to enable louvers to be adjusted to the
desired angles.
• PROVIDE POWER TO ONLY THIS FAN and measure wind speed at target area.
• Remove power from fan and wait until the prop has stopped spinning
• If further adjustment of louvers is needed, then adjust louver/s and retest, repeating process
until desired velocity has been met.
• Once louvers are done being adjusted, using hand tools, tighten all 12 louver bolts to lock in
louver angles (do not over tighten).
40
On/Off - No Speed Control
(Fan Will Run at Full Speed)
0-10V Speed Control with On/Off Relay
0-10V IN
+
Signal
–
STOP/RUN
Signal Ground
0-10V
Control
+
–
STOP/RUN
Relay
Signal
0-10V IN
Signal Ground
0-10V
Control
Relay
4-20ma Speed Control Only
4-20ma Speed Control with On/Off Relay
–
+
Signal
STOP/RUN
Relay
4-20ma +
Signal Ground
4-20ma
Control
with
Relay
4-20ma –
+10V OUT
0-10V IN
STOP/RUN
Signal Ground
Switched
Control
–
+
Signal
STOP/RUN
Signal Ground
4-20ma
Control
4-20ma +
4-20ma –
0-10V Speed Control Only
Common Motor To Control Wiring Options
39
IS297-22F
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 21/27