Installation 7
TM/TMC/RM/RMC-9730CL
2.2.4
Power Supplies and Power Cable Setup
2.2.4 (a) Power Supplies
The TM-9730CL requires 12V DC power that is obtained through the 12-pin connector located on the
rear panel of the camera. JAI Inc. recommends the following power supplies:
PD-12UU
100-240V AC/12V DC
1.2A universal voltage power supply with
US plug (no 12-pin Hirose connector)
PD-12UUP 100-240V AC
1.2A universal voltage power supply with US
plug and 12-pin Hirose connector
PD-12UE
100-240V AC/12V DC
1.2A universal power supply with European plug
(no 12-pin Hirose connector)
PD-12UEP 100-240V AC/12V DC
1.2A universal power supply with European plug
and 12-pin Hirose connector
If you are providing power through the 12-pin connector, the PD-12UUP and PD-12UEP power
supplies are available with the 12-pin mating connector already attached to the leads from the
power supply. The PD-12UU or PD-12UE power supply can be connected to the JAI Inc. power cable
either directly or via a terminal strip.
When wiring the PD-12UU power supply directly, please note the following:
•
The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
•
Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and
shorting.
•
The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
•
All connections must be properly insulated to prevent shorting.
2.2.4 (b) JAI Inc. Power Cables
If you are using JAI Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-
out diagram in “Hirose power and signal integration.” on page 4. The cable pin-out diagram is shown
in Figure 5 below. The color-coded leads use Gray for Ground and Yellow for +12V.
Figure 5.
12P-02S Interface Cable (optional)
Summary of Contents for TM-9730CL
