JAI TM-6740GE, Operation Manual

Page: 37 / 80

Page 25
GigE Series Camera Serial Commands
TM-6740GE Software
5 GigE Series Camera Serial Commands
The GigE series cameras can be controlled by serial command either via RS-232 or Camera Link. The
Start character is always “:” and the End character is always <CR> (return). For example, to set
Asynchronous Pulse Width Mode, send the command :SA9<CR> to the camera. The following table
contains serial commands that can be used to control the camera.
TABLE 4.
TM-6740GE Command List
Command
Command
Parameters
End of
Command
Ack Response Description
Gain, Vtop, and Vbottom Control
:MGA= XXX <cr> :o<cr> Set CDS gain for ch A (DDD = 085 ~ 1E8)
:MGB= XXX <cr> :o<cr> Set CDS gain for ch B (DDD = 085 ~ 1E8)
:MGA? <cr> :oGA[XXX]<cr> Enquire CDS gain for ch A
:MGB? <cr> :oGB[XXX]<cr> Enquire CDS gain for ch B
:EABL <cr> :o<cr> Enable auto gain balance
:DABL <cr> :o<cr> Disable auto gain balance
:ABL? <cr> :oAB[N]<cr>
Check if auto gain balance is enable (N = 1 Enable,
N = 0 : Disable)
ADC Reference Voltage Control
:VRA= XXX <cr> :o<cr> Set reference voltage for ch A (DDD = 000 ~ 1FF)
:VRB= XXX <cr> :o<cr> Set reference voltage for ch B (DDD = 000 ~ 1FF)
:VRA? <cr> :oVA[XXX]<cr> Enquire reference voltage for ch A
:VRB? <cr> :oVB[XXX]<cr> Enquire reference voltage for ch B
Shutter Control
:MSH= S <cr> :o<cr> Set Manual shutter (S = 0 ~ 9)
:DSH= XXX <cr> :o<cr>
Set Direct shutter (DDD = 000 ~ XXX
*
)
:ASH= S <cr> :o<cr> Set Async shutter (S = 0 ~ 9)
:ADS= XXX <cr> :0<cr> Set Async Direct Shutter (DDD=000-81F)
:SHR? <cr> :o[shtr]<cr> Enquire current shutter mode and number
Data Output Control
:DDP= N <cr> :o<cr>
Set output data depth
(N = 0 : 8 bit, N = 1 : 10 bit)