JAI TM-6740GE, Operation Manual

Page: 16 / 80

Page 4
Software Introduction
TM-6740GE Software
1.4.3 Uninstalling the Software
To uninstall the JAI PULNiX GigE camera-control software from the control panel, use the following
steps:
1.
Open “Add or Remove Programs” in the control panel.
2.
Select “JAI Cam2Net” from the lists of the installed software.
3.
Click the “Change or Remove” button
FIGURE 3.
Change and Remove Buttons
1.4.4 Quick-Start
Use the following quick-start process when the Camera Interface Application is installed on your PC.
1.
Connect the camera. The Hirose pin layout is shown in Table 1 on page 6. Both the Hirose and the
network cable (RJ-45) are illustrated in Figure 6.
2.
Run the Camera Interface Application.
3.
Click “Detect.” Assign a suitable IP address to the camera. The window shown in Figure 2 displays.
FIGURE 4. Network Device Finder Window
.