JAI TM-6740GE, Operation Manual

Page: 47 / 80

Page 35
Installation
TM-6740GE Hardware
FIGURE 26.
12P-02S Interface Cable (optional)
Note: Make sure that the unused leads are not touching and that there is no possibility that
exposed wires could cause the leads to short.
7.2.3 (c) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Figure 26 on page 35. Connect the Ground lead to pin #1, and
the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient
current to properly power the camera.
7.2.3 (d) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. To properly attach the power cable to
the camera connector, use the following steps:
1.
Rotate the connector while applying slight pressure until the keyways line up.
2.
Press the connector into place until firmly seated.
3.
Plug the power cord into the 100V AC socket. This powers up the camera.
7.2.4 Attaching the Camera Lens
The TM-6740GE camera accepts 1/3" or larger format size C-mount lenses. To attach the C-mount
lens
1
to the camera, carefully engage the threads and rotate the lens clockwise until it firmly seats on the
mounting ring. Do not force the lens if it does not seat properly.
Note: Some lenses with extremely long flangebacks may exceed the mounting depth of the camera.
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax TTL IN (EXT_VD)
2 Yellow +12V DC 8 White coax shield TTL OUT (STROBE)
3 Red coax shield AGND 9 White coax TTL IN (EXT_HD)
4 Red coax VIDEO 10 Brown RESV
5 Orange coax shield GND 11 Blue TTL IN (INTG_CON)
6 Orange coax TTL IN (EXT_TRIG) 12 Black coax shield RESV
1. C-mount to F-mount and C-mount to K-mount adapters are available for larger format lenses
(35mm). Check with local photography dealers for these lens adapters.
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
GND (Gray)
}
Male
External sync input
Analog Ch. A only