JAI TM-1327GE Series, User Manual, Page: 33 / 52

Hardware Installation 33
TM/ RM -1327GE Series
If you are providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP
power supplies are available with the 12-pin mating connector already attached to the leads from
the power supply. You can connect the PD-12UU and PD-12UE power supplies to the JAI power cable
using a terminal strip or directly.
When wiring the PD-12UU and PD-12UE power supplies directly, note the following:
•
Twist the lead ends together and tin-solder for strength and electrical continuity.
•
Use shrink tubing or a similar insulator to prevent exposed leads from touching and shorting.
•
The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
•
Make sure all connections are properly insulated to prevent shorting.
JAI Power Cables
If you are using JAI power cables, such as the 12P-02S, refer to the Figure 26 which shows the cable
pin-out diagram and pinouts. The color-coded leads use Gray for Ground and Yellow for +12V.
Figure 28. 12P-02S Interface Cable (optional)
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax TTL IN (EXT_VD)
2 Yellow +12V DC 8 White coax shield TTL OUT (STROBE)
3 Red coax shield AGND 9 White coax TTL IN (EXT_HD)
4 Red coax VIDEO 10 Brown RESV
5 Orange coax shield GND 11 Blue RESV
6 Orange coax TTL IN (EXT_TRIG) 12 Black coax shield RESV
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed
wires could cause the leads to short.
Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Figure 26 on page 34. Connect the Ground lead to pin #1,
and the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of
sufficient current to properly power the camera.
Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. To properly attach the power
cable to the camera connector, use the following steps:
1. Rotate the connector while applying slight pressure until the keyways line up.
2. Press the connector into place until firmly seated.
3. Plug the power cord into the 100V AC socket. This powers up the camera.