
GO-5000M-PGE / GO-5000C-PGE
- 17 -
6.2.6 Line Format
Indicates the format of the line item selected in Line Selector.
(No Connect, TTL, LVDS, Opt Coupled or Internal Signal)
Note: In the GO-5000-PGE, TTL and LVDS interface are not equipped.
6.2.7 Action Control
Action control settings allow the use of unicast or broadcast Action Commands as defined in the
GigE Vision 2.0 specification. ACTION_CMD messages received via the GVCP port can control the
camera’s internal action signals provided the camera’s action control settings match the settings of
the message received. This function is useful for triggering an action in multiple cameras at roughly
the same time. There are two action control inputs on the GO-5000-PGE and they are connected to
four triggers, counter reset, counter, and timer.
When action control is used, the trigger input source should be set to Action 1 or Action 2 in
advance.
6.2.7.1 ActionDeviceKey
Sets the device key value for the camera in a 32-bit register. This value must match the device_key
value of the ACTION_CMD message in order for the message to be acted upon. .
6.2.7.2 ActionSelector
Selects Action 1 or Action 2 for setting the action control values.
6.2.7.3 ActionGroupKey
Sets the group key value for the selected action signal in a 32-bit register. This value must match
the group_key value of the ACTION_CMD message in order for the message to be acted upon.
6
.2.7.4 ActionGroupMask
Sets the mask value for the selected action signal in a 32-bit register. This value is compared against
the group mask value of the ACTION_CMD message to determine if the message should be ignored or
acted upon. A logical AND operation is used and must produce a non-zero result or else the message
is ignored..
6.2.8 GPIO
This is a general interface for input and output and controls input and output for trigger signals or
valid signals and pulse generator. By using this interface, you can control an external light source,
make a delayed function to input a trigger signal or make a precise exposure control with PWC
trigger.