![background image](http://html1.mh-extra.com/html/jai/ab-1600cl/ab-1600cl_user-manual_631442049.webp)
AM-1600CL / AB-1600CL
- 49 -
Calibration must be performed in the sequence of [Dark] first, then [Bright]. Begin by
clicking the [
RUN
] button in the [Dark] section. A pop-up window will instruct you to
close the lens before continuing. Calibration will then proceed automatically untill
completed. The status window next to the [
STOP
] button shows the percentage of
completion. It can take up to 20 minutes for a calibration to be performed. Click the
[
Stop
] button to halt the calibration at any time.
When [
Dark
] calibration is completed, click the [
RUN
] button in the [
Bright
] section. You
will be prompted to open the lens to a saturation level of approximately 50% before
continuing. Calibration will then proceed automatically unless halted by clicking the
[
STOP
] button.
Both [Dark] and [Bright] calibration must be performed as a set. [Dark] only or [Bright]
only cannot be initiated.
After running both [
Dark
] and [
Bright
] calibration, the data should be saved to Flash
memory to avoid having to rerun calibration. Click [
Start
] button in the [
Save
] section to
save the data. The process can take up to 40 minuates.
If a flat field compensation mode has been selcted and saved via the [
Save RAM to Flash
]
command on the Gain & Offset page, the calibration settings will be automatically loaded
to the Camera at start-up (the rear panel indicator light will turn red during the loading
process, which may last a few minutes).
Use the [
Load
] section to load pre-saved calibration data from Flash to RAM.
Use the [
verify
] section to compare new calibration data in RAM to saved data in Flash
memory.
8.7.2(d) Utilities
On this screen, model name, firmware versions and test patterns are indicated.
Summary of Contents for AB-1600CL
Page 28: ...AM 1600CL AB 1600CL 28...
Page 60: ...AM 1600CL AB 1600CL 60...
Page 61: ...AM 1600CL AB 1600CL 61...